|TS400-DM Operator module serial|
Up to TS400 DM Operator modules can be integrated into one system. The messages can be assigned selectively. The TS400 DM Operator module serial is connected to the CPU's serial interface or to the Technet unsing a LAN-modem (Lan to serial adapter).
Thanks to its flat design, the display and operator module can be mounted directly on front panels, walls or to the work surface via a monitor stand.
The TS400 DM Operator module serial uses the same wire assignment as the Power over Ethernet Technology. Therefore, only one cable is necessary to connect the TS400 DM. Please make sure that the used cables are fully equipped and not crossed. PIN 6 must not be used.
|Description||TX||RX||GND (5V)||24V+||24V+||5V+||GND (24V)||GND (24V)|
Connection Principle TS400 DM Operator module serial
The TS400 DM Operator module serial can be integrated in the TS400 annunciator system in two ways:
-Local directly connected to the CPU's serial interface. An adapter for the power supply has to be connected
-External integrated in the network (Technet) using a LAN-modem, also in this case, an adapter for the power supply has to be connected
|Type||TS400 DM Operator module serial|
|Display||LCD 16 lines x 30 characters, backlit, supports graphics|
0 to +55 °C
-20 to +75 °
|Mounting||-cabinet front 114x163mm M4
-monitor stand VESA 75x75mm
-wall bracket VESA 75x75mm
|Protection category||IP 40|
|Dimensions (B x H x T)||250 x 175 x 24|