TS200
 Description
View
Technical data
Downloads
TS200 CPU processor module





Description

The CPU processor module is the command centre for the TS200 Fault monitoring system. It receives and processes data and sends such data to other units. The CPU is currently available in two memory versions. The size of the memory dictates the maximum possible expansion of the system.




View



TS200 CPU The following is located on the front of the CPU:
(1) Function indicators via LEDs
(2) SL1 and SL2 card slots
(3) DIP switch bus configuration
(4) Terminals for outputs (O) and supply (0 V, US)
(5) Service port (D-Sub-9)
(6) Battery compartment




TS200 CPU The following is located on the reverse side of the CPU:
(7) printer port (D-Sub-9)
(8) bus connection (D-Sub-9)





Technical data

Main memory
RAM
Flash-EPROM
256 kB / 1 MB
512 kB / 1 MB
Processing capacity
I /O-channels
I/O-nodes
Control modules
256 / 1280
4 / 20
7 / 7
Real time clock
Max rate variation (at 25 °C)
yes
6 sec/day
Digital outputs (device fault) )
Output type
Display Output status
Signal level without load
Signal = 0
Signal = 1
Signal = 1, I = 0.1 A, US = 24 VDC
Output current (signal = 1),
Short circuit current
Total loading capacity
Minimum switching current
Inductive cut-off voltage limitation
Consequences of overloading 		2 (continuous and flashing)
FET, positive-switching
LED, orange (signal = 1)

max. +2 VDC
+18 .. +36 VDC
max. +22 VDC
max. 0.1 A
typ. 0.5 A
0.2 A
100 A
Self induction recuperation diode
Current limiting and temperature cut-off
Serial interfaces
Printer (X2), service (X1)
Bus connection CAN (ISO 11898)
US power supply
operating range
limits
power consumption
 24 VDC NOM
+18 to +36 VDC
-36 to +36 VDC
max. 6 W
Electrical isolation
Feed / logic, bus
Output / logic, bus
Serial connection / logic, bus
Output / output
Feed / output
yes
yes
yes
no
no
Ambient temperature
Operating
Storage
0 to +55 °C
-40 to +80 °
Protection category
 IP 30
Dimensions (W x H x D)in mm 181 x 70 x 132
Weight
 695 g






Downloads